![]() You can view stock levels in the Stock Status section on our product pages.Ĭheck our store opening hours for Click & Collect availability. Click and Collect availabilityĬurrently Click and Collect is available at all stores for items that are in stock. Orders over $2,000 AUD in value are not eligible for Click and Collect pickup. Click and Collect limitationsĬlick and Collect is not available for all items. Please wait until that notification has been received before coming into the store. You will receive an email confirming that your order is ready for collection. No, due to security risks our current Click and Collect policy requires the cardholder to pickup the goods, and bring the credit card with them.įor PayPal orders, the PayPal account name must match the ID shown to staff when picking up. PayPal orders: Passport/Driver's License, PayPal transaction ID and your Order Number (found in your confirmation email).Ĭan someone else pick up the items for me?.Credit Card orders: Passport/Driver's License, Credit Card used for the purchase and your Order Number (found in your confirmation email).Always check that the battery cap O-ring and screw threads are clear of dust, sand, and grit. Full sensitivity is too sensitive it senses nearly every piece of metal nearby, almost unusable in. I use mine successfully by using it one notch down from full. The profind 35 is extremely sensitive when turned on with full sensitivity. To maintain a waterproof/splash proof seal, ensure that the battery cap O-ring is periodically lubricated with silicone grease. Hi VicGoldHunter, Re: MineLab Pro Find 35. One long beep followed by two short beeps will indicate when Factory Reset is complete. After two long beeps, continue to hold for 5 seconds. If + or – are not pressed at all when turning on the pinpointer, it will default to the last-use audio mode.įrom off, press and hold the Power button (5). To turn audio tones OFF, hold down – when turning on the pinpointer. To turn audio tones ON (default), hold down + when turning on the pinpointer. To disable Ferrous Tone ID, press and hold – for 3 seconds, until the unit emits one long beep. Ferrous Tone ID is effective when the probe is 10–15 mm (approx. When the pinpointer is close to the target: Interrupted chirping tones upon detection indicate a ferrous target. To enable Ferrous Tone ID, hold the pinpointer away from metal objects, then press and hold + (6) for 3 seconds. ![]() When minimum sensitivity is exceeded (level 1), there will be a long beep. When maximum sensitivity is exceeded (level 5), there will be a long beep. When the battery level is critically low, the pinpointer will automatically power off. Low Battery is indicated by a flashing LED. If the pinpointer is inactive for another 5 minutes, it will automatically power off. This will repeat every 10 seconds unless a detection occurs. When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. Low Battery Low Battery is indicated by a flashing LED. Lost-Alarm When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. Three short beeps will emit and the pinpointer will power off. When the detected object is very close to the probe, the beep becomes a continuous tone. When a detection occurs, the vibration will intensify, and the beeps will emit increasingly closer together. When auto-calibration is complete, a short beep indicates that the pinpointer is ready to use. The unit will beep twice and the LED (3)* will illuminate. With probe at least 300mm/1' away from metal objects, press the Power button.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |